TO INSTALL AND REPLACE BATTERIES IN THE WEATHER PROJECTION STATION
The Weather Projection Station uses 3 x AA, IEC LR6, 1.5V batteries. To install and replace the batteries, please follow the steps below:
1.Insert finger or other solid object in the space at the bottom center of the battery compartment and lift up to remove the cover.
2.Insert batteries observing the correct polarity (see marking).
3.Replace compartment cover.
TO INSTALL AND REPLACE BATTERIES IN THE THERMO- HYGRO SENSOR
The
1.Remove the battery cover.
2.Insert the batteries, observing the correct polarity (see marking).
3.Replace the battery cover on the unit.
Note:
In the event of changing batteries in any of the units, all units need to be reset by following the setting up procedures. This is due to a random security code assigned by the sensor at
BATTERY CHANGE:
It is recommended to replace the batteries in all units on an annual basis to ensure optimum accuracy of these units.
Please participate in the preservation of the environment. Return used batteries to an authorized depot.
SETTING UP
The Weather Projection Station can be either