La Crosse Technology WS-9025U Toggling And Resetting The Outdoor Recordings, Back-Light

TOGGLING AND RESETTING THE OUTDOOR RECORDINGS:

1.To toggle between the outdoor current, MIN/MAX temperature and humidity data and the times (for temperature data only) they were recorded press the MIN/OUT key:

Once to show the MAX outdoor temperature and humidity data with the recorded time and date.

Twice to show the MIN outdoor temperature and humidity data with the recorded time and date.

Three times to return to the current displayed values.

2.To toggle between sensors, press the CH/+ key: Once to show sensor 2

Twice to show sensor 3

Three times to return to sensor 1

Note: The sensor number will only be displayed if there is more than one sensor being used.

3.To reset the MIN/MAX outdoor temperature, and the time at which they were recorded, press and hold the MIN/OUT key for about 4 seconds. This will reset all MIN/MAX data recorded to the displayed values for that particular sensor.

TO EXIT THE MANUAL SETTING MODE

To exit the manual setting mode anytime during the manual setting modes, press the SNOOZE key anytime or wait for automatic timeout. The mode will return to normal time display.

BACK-LIGHT

The back-light is automatically switched ON when any keys are pressed. The back-light will be switched on for approximately 10 seconds before automatically switching OFF. However, if the SNOOZE key is pressed and held down, then back-light will remain ON constantly until the key is released.

ABOUT THE OUTDOOR THERMO-HYGRO SENSOR

The range of the Thermo-hygro Sensor may be affected by the temperature. At cold temperatures the transmitting distance may be decreased. Please bear this in mind when positioning the sensor. Also the batteries may be reduced in power.

CHECKING FOR 433MHz RECEPTION

If the outdoor temperature and humidity data is not being received within three minutes after setting up (the display shows “- -. - °F” and “- -%” on the outdoor section of the Weather Projection Station after 3 attempts during normal operation), please check the following points: