Land Pride DM36 Series manual Cutter Bar Timing Adjustment, Table of Contents, Refer to Figure

Land Pride Table of Contents

Section 4 Maintenance and Lubrication

Cutter Bar Timing Adjustment

Removal of disc shaft assemblies

Refer to Figure 4-3:

1.Rotate the long axis of the discs adjacent to the replaced shaft assembly 90 degrees to the long axis of the cutter bar.

2.Line up the new gear’s mounting holes with holes in the cutter bar. Rotate gear so that the axis of two of the disc mounting holes are 90 degrees to the long axis of the cutting bar (figure 4-3). Try sliding gear into place. This step may need to be repeated, using the nest pair of holes until the gear will slide into place. Apply sealant between gear assembly housing and cutter bar then bolt housing into place.

3.When gear is lined up correctly, the disc will now mount to the gear with it’s long axis parallel to the long axis of the cutter bar (90 degrees to the axis of the adjacent discs).

Disc Assembly

Figure 4-3

5/5/08 DM36 Series Disc Mowers 327-045M 19