Land Pride DM36 Series Danger, Cutting Unit Assembly, Table of Contents, Assembly and Set-Up

Land Pride Table of Contents

Section 1 Assembly and Set-Up

Cutting Unit Assembly

Refer to Figure 1-5:

1.Install the support frame (#2) to the gearbox using the M16 bolts (#18) and lock washers (#29).

2.Assemble the blade bar support (#4) to the support frame (#2) using the 3/8” X 2 3/4” long bolts (#15) and lock nuts (#20).

3.Assemble the blade bar support (#4) to the cutting unit and secure with 1/2” X 1 1/2” bolt (#12), lock washer (#26) and nut (#21).

4.Attach shield brackets (#7), (#8) and (#9). Bracket (#7) is assembled with the longer socket head bolt. Bracket (#8) is assembled with a 1/2” X 1 1/4” long bolt (#16) and lock nut (#23). Bracket (#9) is assembled with the shorter socket head bolt (#17) and lock washer.

5.Assemble shield (#6) to brackets with carriage bolts (#14), washers (#24) and lock nut (#22).

6.Assemble the guide (#5) to the cutting unit with the 1/2” X 3 1/2” long bolt (#11), flat washer (#27) and lock nut (#23). Place the spring (#33) between the guide (#5) and flat washer (#27).

7.Assemble the front tarp frame (#1) and rear tarp frame (#3) to the support frame (#2) using 3/8” X 2 1/2” bolts (#13), lock washers, nuts (#20), pins (#32) and hair pin cotters (#31) to secure.

8.Position tarp over frame (#3) so the sewn end is towards the gearbox with cut out sliding down over (#2). Pull the other end of the tarp over the other end of the frame and slip the eyelets over the tarp frame ends. Fasten tarp to frame using cable ties (#34) and (#25).

9.Assemble bumpers (#10) to tarp frames with cotter pins (#30).

!DANGER

Do not operate cutting unit without tarp in place!

Cutting Unit
Figure 1-5	20769

5/5/08 DM36 Series Disc Mowers 327-045M 11