Land Pride FDR3590 Problem Solution Discharge chute plugged, Belt slipping, Excessive vibration

Table of Contents

Section 7: Troubleshooting

Problem	Solution
Discharge chute plugged	Check installation of belt.
	Wait until grass dries.
	Raise cutting height of mower and cut grass twice.
	Mow at full throttle (540 PTO rpm), check PTO speed and tractor engine.
	Shift transmission to a lower gear.

!CAUTION

Do not try to clean discharge chute when mower is running. Bodily harm may occur!

Belt slipping	Unplug and clean mower deck.
	Remove belt guard shields and clean sheaves.
	Tighten spring take-up eyebolt.
	Replace belt.
Patches of uncut grass	Mow at full throttle (540 PTO rpm), check PTO speed and tractor engine.
	Shift transmission to a lower gear.
	Tighten spring take-up eyebolt.
	Sharpen and balance or replace blade.
Excessive vibration	Remove belt guard shield and clean debris from belt area and sheaves. Replace
	the belt guard shield.
	Replace drive belt.
	Replace sheaves or align.
	Readjust 3-point hitch to raise mower to maximum of 14 inches.
Gearbox noisy	Check lubricant level.
Blades scalping grass	Raise cutting height by adjusting wheels.
	Change mowing pattern.
	Reduce speed turns.
Uneven cut	Shift to a lower gear.
	Level mower.
	Sharpen blades & balance or replace. Shimming of blade hubs may be required to
	level out all three blades. Blade hub shim part no. 310-367D (Optional).
Tractor loaded down by mower	Mow at full throttle (540 PTO rpm).
	Shift to a lower gear.
	Clean mower.

24 FDR3590 Rear Discharge Grooming Mowers 310-229M 12/10/07