Land Pride PS25120 Values Chart in “ Appendix” on page, Table of Contents, Assembly and Set-up

Table of Contents

Section 1: Assembly and Set-up

Land Pride

12740

Cylinder, Wheel Bracket & Wheel Arm Assembly

Figure 1-10

Refer to Figure 1-11:

13.Install 3 1/2” x 8” x 1 1/4” hydraulic cylinder (#1) 3 1/ 4” x 8” x 1 1/4” hydraulic cylinder (#2) and complete

the plumbing as shown. Route the hydraulic hoses (#3) through the spring hose loop and along the tongue, underneath the turnbuckle, behind the upper hitch and through the holes in the box supports, finishing with the hoses going through the hose retainers on the top of the wheel brackets. Route the hydraulic hose (#4) through the holes in the box supports, and finishing with the hose going through the hose retainers on the wheel brackets. Any excess hose should be coiled and tied with a plastic tie, placing the coil between the upper hitch. Position hose clamp (#5) & (#6) as shown and fasten together with 5/16" x 1 1/4" long carriage bolt (#7) and 5/16" flange nut (#8) adding the hoses from step 7. Secure hoses to tongue using one of the plastic cable ties provided.

NOTE: Your Front Wheel Seeder is equipped with rephasing hydraulic lift cylinders. The plumbing must be assembled correctly in order for the rephasing cylinders to function properly.

15259

14. Check to see all nuts are tightened. See Torque	Front Wheel Hydraulic Schematic
Values Chart in “Section 9: Appendix” on page 48
	Figure 1-11
for additional torque specifications.

12 PS25120 Primary Seeder 313-156M 8/21/06