Land Pride | Table of Contents |
Section 1: Assembly and Set-up
3.Refer to Figure
15257 |
Acremeter Installation
Figure
4.Check to see all nuts are tightened. See Torque Values Chart in “Section 9: Appendix” on page 48 for torque specifications.
Pull-Type Primary Seeder
1.Remove the seeder and components from their crating.
2.Attach the tongue to the seeder with hitch pins (#1). Attach the turnbuckle (#2) to the tongue and the top hitch of the seeder with hitch pins (#3), refer to Figure
12736 |
Tongue & Turnbuckle Assembly
Figure
3.Refer to Figure
4.Check to see all nuts are tightened. See Torque Values Chart in “Section 9: Appendix” on page 48 for torque specifications.
Pull-Type Primary Seeder with End Wheels
!WARNING
Serious injury or death could result from escaping high pressure hydraulic fluid. Use paper or cardboard, NOT BODY PARTS, to check for suspected leaks.
1.Remove the seeder and components from their crating.
2.Follow steps 2 and 3 of the
3.Install spring hose loop (#1) to tongue with 5/16" x 3/4" long bolts (#2), 5/16" lock washer (#3), and 5/16" USS flat washer (#4), Figure
12737 |
Spring Hose Loop Assembly
Figure
Refer to Figure 1-6:
4.Starting with the left hand side of the seeder, remove the four 5/8" bolts and attach the end wheel mount (#1) to the seeder frame replacing the 5/8" bolts with 5/8" x 2 1/4" long bolts (#2). Flat washers (#3) are used between the end wheel mounts and the seed box for proper spacing.
5.Install the wheel bracket using 3/4"
NOTE: The wheel bracket (#7) should be facing the rear of the seeder. To determine the correct positioning for the wheel brackets, note the tab (#8) on the end of the wheel arm pivot (#9). This tab should be facing away from the seeder, as shown, so the wheel arm pivot can be easily removed.
8/21/06 | PS25120 Primary Seeder |
