Table of Contents

Section 1: Assembly and Set-up

Land Pride

12738

Wheel Bracket & Wheel Arm Assembly

Figure 1-6

6.Remove wheel arm pivot shaft from wheel bracket.

7.Position the wheel arm (#10) so that the wheel points away from the seeder with cylinder bracket up. Replace wheel arm pivot shaft.

8.Pin the cylinder lock (#11) in storage position.

9.Repeat steps 5-9 for the right hand side.

Refer to Figure 1-7:

10.Install 3 1/4” x 8” x 1 1/4” hydraulic cylinder (#1) and 3 1/2” x 8” x 1 1/4” hydraulic cylinder (#2) and complete the plumbing as shown in Figure 1-7. Route the hydraulic hoses (#3) through the spring hose loop and along the tongue, behind the upper hitch and through the holes in the box supports, finishing with the hoses going around the frame end plates and through the hose retainers on the top of the wheel brackets. Route the hydraulic hose (#4) through the holes in the box supports, and finish with the hose going around the frame end plates and through the hose retainers on the top of the wheel brackets. Any excess hose should be coiled and tied with a plastic tie, placing the coil between the upper hitch. Position hose clamp (#5) & (#6) as shown and fasten together with 5/16" long carriage bolt (#7) and 5/16" flange nut (#8). Secure hoses to tongue using one of the plastic cable ties provided.

NOTE: Your End Wheel Seeder is equipped with rephasing hydraulic lift cylinders. The plumbing must be assembled correctly in order for the rephasing cylinders to function properly.

11.Check to see all nuts are tightened. See Torque Values Chart in “Section 9: Appendix” on page 48 for torque specifications.

15258

End Wheel Hydraulic Schematic

Figure 1-7

10 PS25120 Primary Seeder 313-156M

8/21/06

Page 12
Image 12
Land Pride PS25120 manual Wheel Bracket & Wheel Arm Assembly, End Wheel Hydraulic Schematic