Land Pride PS25120 manual Pull-Type Primary Seeder with Front Wheels, Accumulator Assembly

Land Pride Table of Contents

Section 1: Assembly and Set-up

Pull-Type Primary Seeder with Front Wheels

!WARNING

Serious injury or death could result from escaping high pressure hydraulic fluid. Use paper or cardboard, NOT BODY PARTS, to check for suspected leaks.

1.Remove the seeder and components from their crating.

2.Refer to Figure 1-3 on page 8 for installation of the acremeter on to the right hand drive shaft.

3.Install spring hose loop, Figure 1-5 on page 8.

!CAUTION

The Accumulator/Cylinder Package furnished with your front wheel option is provided for your protection. Lack of or improper installation may result in injury or in damage to your seeder because of the negative tongue weight involved with the front wheels.

4.Attach the tongue to the seeder with hitch pins.

5.Refer to Figure 1-8 and attach the accumulator bracket and accumulator to the rear of the tongue as shown, fastening with hose clamps provided.

12739

Accumulator Assembly

Figure 1-8

6.Refer to Figure 1-10 and install hydraulic cylinder with single lug (#1) to tongue and top hitch as shown.

7.Complete the plumbing by following the schematic in Figure 1-9. The plumbing must be assembled correctly in order for the accumulator to function properly. Route the hydraulic hoses (#1) along the tongue. These hoses will be clamped together with the wheel cylinder hoses in step 13.

15501

Accumulator Hydraulic Schematic

Figure 1-9

Refer to Figure 1-10:

8.Install the wheel bracket (#2) using 3/4" u-bolts (#3), flat washers (#4) and nuts (#5). The wheel bracket should be facing the front of the seeder. To determine the correct positioning for the wheel brackets, note the tab (#6) on the end of the wheel arm pivot (#7). This tab should be toward the outside of the seeder, as shown, so the wheel arm pivot can be easily removed.

NOTE: The corresponding wheel brackets must be positioned with the 1" hole over the front wheel locating stub (#8) on the frame as shown for proper distribution of seeder weight when in transport. Locating the brackets at any other place on the frame could result in damage to the seeder.

9.Remove wheel arm pivot shaft from wheel bracket.

10.Position the wheel arm (#9) so that the wheel points toward the outside of the seeder with cylinder bracket up. Replace wheel arm pivot shaft.

11.Pin the cylinder lock (#10) in storage position.

12.Repeat steps 9-11 for the right hand side.

8/21/06 PS25120 Primary Seeder 313-156M 11