Land Pride RCR1872 Center 3-Point Link Length, Tailwheel Height Adjustment, Refer to -3 on page

Land Pride

Section 3: Adjustments

Table of Contents

Center 3-Point Link Length

Refer to Figure 1-3 on page 9:

1.Lower cutter deck to the nominal cutting height.

2.Adjust length of center 3-point link so that the upper pivot hitch rest at a slight downhill position. This arrangement allows for optimum ground contour following performance.

3.Lock center link in this position once correct length is achieved.

4.The second set of holes on the upper pivot hitch should be used when tractor’s center 3-point link is too short.

Tailwheel Height Adjustment

Refer to Figure 3-3:

If deck slope is slightly lower at the front than at the back and cutting height is not at the desired height, then the tailwheel must be adjusted up or down as follows:

1.Use tractor’s 3-point hydraulic control to lift cutter until the tailwheel clears the ground.

2.Remove carriage bolt (#1) and 5/8” flange nut (#2).

3.Adjust tailwheel as follows:

•To lower cutting height, adjust tailwheel up.

•To increase cutting height, adjust tailwheel down.

4.With tailwheel adjusted to the correct height, replace 5/8” x 1 1/2” long carriage bolt (#1) and 5/8” flange nut (#2). Tighten flange nut to the correct torque.

5.Readjust tractor’s lower 3-point arm height as needed. See section titled “Deck Cutting Height” on page 14.

21421

Tailwheel Height Adjustment

Figure 3-3

12/17/07 RCR1860 and RCR1872 Series Rotary Cutters 312-849M 15