
Table of Contents
Section 8: Troubleshooting
Problem | Cause | Solution | |
|
|
| |
Oil seal leaking | Gearbox overfilled | Drain to side plug hole | |
|
|
| |
| Seals damaged | Replace seals | |
|
|
| |
| Grass or wire wrapped on | Check seal areas daily | |
| shaft in seal area |
| |
|
|
| |
Driveline yoke or cross failing | Shock load | Avoid hitting solid objects | |
|
|
| |
| Needs lubrication | Lubricate every 8 hours | |
|
|
| |
Driveline | Scalping the ground | Raise cutting height | |
clutch slipping |
|
| |
| Cutting too fast | Reduce travel speed | |
|
|
| |
| PTO being engaged too | Slowly engage PTO at low engine rpm | |
| fast at high engine rpm |
| |
|
|
| |
| Cutting over solid objects | Avoid solid objects | |
|
|
| |
Bent Driveline (NOTE: driveline should | Contacting frame | Reduce lift height in transport position | |
be repaired or replaced if bent) |
|
| |
Contacting drawbar | Reposition drawbar | ||
| |||
|
|
| |
| Bottoming out | Shorten driveline | |
|
|
| |
| Binding up | Not lubricating enough | |
|
|
| |
Driveline | Shock load | Avoid hitting solid objects | |
telescoping tube failing |
|
| |
|
|
| |
Driveline | Needs lubrication | Lubricate every 20 hours | |
telescoping tube wearing |
|
| |
|
|
| |
Blades wearing excessively | Cutting on | Raise cutting height | |
| sandy ground |
| |
|
|
| |
| Contacting | Raise cutting height | |
| ground frequently |
| |
|
|
| |
Blades breaking | Hitting solid objects | Avoid hitting solid objects | |
|
|
| |
Blades coming loose | Blades not | Tighten blade hardware (refer to “Service Cutter | |
| tightened properly | Blades” on page 19 | |
|
|
| |
| Improper deck attitude | Lower front of deck, see page 15 | |
|
|
| |
Blade carrier becomes loose | Running loose in the past | Replace gearbox output shaft and blade carrier | |
|
|
| |
| Blade carrier hardware not | Tighten to specified torque | |
| tight enough |
| |
|
|
| |
Blade bolt holes worn | Blade hardware running loose | Replace blades and blade bolts if worn | |
|
|
| |
Blade carrier bent | Hitting solid objects | Avoid hitting solid objects and replace blade carrier | |
|
|
| |
Excessive side skid wear | Cutting height not level | Adjust cutter height | |
|
|
| |
| Soil abrasive | Adjust cutter height | |
|
|
| |
| Cutting too low | Adjust cutter height | |
|
|
| |
Tailwheel support failing | Lowering too fast | Adjust rate of drop | |
|
|
| |
| Hitting objects when turning | Reduce speed on turns | |
|
|
|
26 RCR1860 and RCR1872 Series Rotary Cutters | 12/17/07 |