Table of Contents
Section 1: Assembly and
Land Pride
3-Point Hitch Assembly
IMPORTANT: Tighten all flange lock nuts snug. DO NOT torque nuts tight. All connections must be allowed to pivot.
Refer to Figure
1.Remove inside linch pins (#17) and assembly hitch straps (#2A & #2B) over threaded bushings (#16) as shown. Install 1 1/4” flat washers (#15) and secure with 1 1/4” lock nuts (#14). Tighten lock nuts to the correct torque. Reference Torque Chart on page 33.
2.Reinstall linch pins (#17).
3.Assemble rear hitch braces (#3) to the inside of rear strap lugs (#13) with
4.Rotate hitch straps (#2A & #2B) up as shown and Insert
5.Insert
6.Pivot hinge bars (#4) up and insert stop pin (#1) in the hinge bars (#4) as shown. Stop pin must be positioned above the rear hitch braces (#3) when completed. See “Figure
7.Insert 2 cotter pins (#12) in the stop pin as shown. Secure cotter pins by bending one leg of each cotter pin 45 degrees or more.
Draw Lock nuts 8A & 8B up snug
and then back off 1/4 turn.
24654
Figure
10 RCR1884 Series Rotary Cutters | 9/24/08 |