Land Pride | Table of Contents |
Section 1: Assembly and Set-Up
Tractor Requirements
Weight & Horsepower
Tractor horsepower and weight must be capable of controlling the cutter under all operating conditions. Tractors outside the horsepower range must not be used.
•RCS3596 cutters & RCSM3596
•RCS3510 & RCSM3510 cutters
NOTE: Ballast may need to be added to your tractor to maintain steering control. Refer to your tractor’s operator manual to determine if one needs additional ballast.
PTO Type & Speed
Tractor’s rear power
•RCS3596 and RCS3510 cutters
540RPM 1
•RCSM3596 and RCSM3510 cutters
1000 RPM 1
3-Point Hitch
The lower
•RCS3596 & RCSM3596 (Category l or ll hitch)
•RCS35510 & RCSM3510 (Category ll or lll hitch)
Dealer Preparations
Read and understand the operator’s manual for your cutter. An understanding of how it works will aid in the assembly and setup of your cutter.
This Rotary Cutter has been partially assembled at the factory. However, some assembly will be necessary to attach the hitch, driveline and guards to the cutter.
It is best to go through the
Pre-Assembly Checklist
Check | Reference |
Fasteners and pins that were shipped | Operator’s |
with the cutter. NOTE: All hardware from | Manual |
the factory has been installed in the |
|
location where it will be used. If a part or |
|
fastener is temporarily removed for |
|
assembly reasons, remember where it |
|
goes.Keep the parts separated. |
|
|
|
Be sure the parts get used in the correct | Operator’s |
location. By double checking while you | Manual |
assemble, you will lessen the chance of |
|
using a bolt incorrectly that may be |
|
needed later. |
|
|
|
All grease fittings are in place and | Section 4 |
lubricated. | Page 21 |
|
|
Safety labels are correctly located and | Safety |
legible. Replace if damaged. | Information |
| Page 1 |
|
|
Red and amber reflectors are correctly | Safety |
located and visible when the cutter is in | Information |
the transport position. | Page 1 |
|
|
Have a minimum of 2 people at hand | Operator’s |
while assembling the cutter. | Manual |
|
|
Have a fork lift or loader along with | Operator’s |
chains and safety stands that are sized | Manual |
for the job ready for the assembly task. |
|
|
|
6/26/06 | RCS3596, RCSM3596, RCS3510 & RCSM3510 Series Rotary Cutters | 9 |