Table of Contents
Section 1: Assembly and
Land Pride
Hitch Assembly
NOTE: Do not tighten hardware until assembly is complete. Refer to “Torque Values Chart for Common Bolt Sizes” on page 28.
Refer to Refer to Figure 1-1:
1.Install the offset arms (#2) to the cutter making sure the pinch decals on the arms are to the top and front of the cutter and assemble the mounting caps (#5).
Secure with bolts (#7) lockwashers (#11) and nuts (#9).
2.Assemble the hitch (#1) to offset arms (#2) inserting the tubes (#6) in the offset arms and secure with bolts (#8) lockwashers (#12) and nuts (#10).
3.Assemble rod end of cylinder (#3) to hitch lug with pin (#13). Cylinder’s hydraulic elbows should be facing away from offset arms.
4.Assemble the lift cylinder (#3) or ratchet jack (#14) to lift lug on the deck and the rear axle and secure with pins as shown.
20703 |
Tailwheel Assembly
Figure
Tailwheel Assembly
Refer to Refer to Figure
1.Assemble tailwheel arms (#3) to rear axle with
2.Install tailwheel washer (#2) (larger diameter washer) on the tire yoke (#1) and insert yoke into tailwheel arms.
3.Place washer (#5) on yoke on top side of tailwheel arms (#3) and secure with roll pin (#6).
Driveline Installation
1.Attach the
2.Secure the chain on the driveline to the driveline cone to restrict outer shield from rotating.
20702
Hitch Assembly
Figure
10 RCS3596, RCSM3596, RCS3510 & RCSM3510 Series Rotary Cutters | 6/26/06 |