Land Pride | Table of Contents |
Section 1: Assembly &
Skid Shoe Assembly (Optional)
Refer to Figure
Cutters ordered with skid shoes are shipped loose. Install skid shoes as follows:
1.Raise the Rotary Cutter 3" or more off the ground and place support blocks under the cutter. Make sure support blocks are positioned so they will not interfere with skid shoe installation.
2.Lower cutter onto support blocks, place Skid Steer in park, set park brakes, shut Skid Steer off and remove switch key.
3.Install short skid shoe (#2) to the back left deck corner as shown with
4.Install long skid shoes (#1) to the remaining three deck corners with
5.Raise cutter up and remove support blocks.
24546 |
Skid Shoe Replacement
Figure
Operator Protective Door (Optional)
Refer to Figure
!WARNING
Do not drill holes in the ROPS (Roll Over Protection System) to attach this Operator Protective Door. Drilling unapproved holes in the ROPS can weaken the structure and void its warranty.
1.Cut notches in protective door as needed to provide clearance around
2.Install Operator Protective Door to the Skid Steer’s hand hold with two
Skid Steer
Hand Hold
If needed, Locate & Cut
Notches in Door For
Hook Elastic
To Skid Steer Cage To
Keep Door Closed.
If Needed, Locate
&Cut Notch in Door To Clear Skid Steer Frame.
24608
Operator Protective Door
Figure
1/07/09 | SC2660 & SC2672 Skid Steer Rotary Cutter | 13 |