Table of Contents
Section 8: Troubleshooting
Troubleshooting Chart
Problem | Cause | Solution |
|
|
|
Motor Oil Seal Leaking | Return line from motor has been pinched | Replace lower seal of motor. Check motor |
| or is collapsed. | return hose for kinks. |
|
|
|
| Case drain line is not properly connected. | Connect case drain line to the hydraulic |
|
| motor and skid steer reservoir. |
|
|
|
Spindle Hub Seal Leaking | Return line from motor has been pinched | Replace lower seal of motor and Spindle |
| or is collapsed. | Hub output shaft seal. Check motor return |
|
| hose for kinks. |
|
|
|
Blades wearing excessively | Cutting on sandy ground. | Raise cutting height. |
|
|
|
| Contacting ground frequently. | Raise cutting height. |
|
|
|
Spindle Hub Seal Leaking | Return line from motor has been pinched | Replace lower seal of motor and Spindle |
| or is collapsed. | Hub output shaft seal. Check motor return |
|
| hose for kinks. |
|
|
|
Blades coming loose | Insufficient shimming. | Add shimming. See text. |
|
|
|
| Blade bolts not tightened properly. | Torque blade bolt nuts to 450 ft lbs. |
|
|
|
Blade carrier becomes loose | Running loose in the past. | Replace gearbox output shaft and blade |
|
| carrier. |
|
|
|
| Blade carrier hardware not tight enough. | Tighten to specified torque. |
|
|
|
Blade bolt holes worn | Blade hardware running loose. | Replace blades and blade bolts if worn. |
|
|
|
Blades breaking | Hitting solid objects. | Thoroughly check the cutting area |
|
| BEFORE beginning to cut. Be alert during |
|
| cutting. |
|
|
|
Loose Blade Carrier | Worn spindle hub bearings. | Replace Spindle Hub bearings and/or |
|
| shaft. |
|
|
|
| Shaft nut loose. | Tighten Spindle Hub shaft nut to 450 ft lbs. |
|
|
|
Blade Carrier bent | Hitting solid objects. | Avoid solid objects/Be alert. |
|
|
|
Gauge wheel support failing | Lowering too fast. | Adjust rate of drop. |
|
|
|
| Hitting objects when turning. | Reduce speed on turns. |
|
|
|
Excessive skid shoe wear | Cutting height not level or blade missing. | Adjust deck height or replace. |
|
|
|
| Soil abrasive. | Raise cutting height. |
|
|
|
| Cutting too low. | Raise cutting height. |
|
|
|
Excessive vibration | Locked blades. | Inspect and unlock blades. |
|
|
|
| Blades have unequal weight. | Replace blades as a PAIR. |
|
|
|
| Blade carrier bent. | Replace / straighten blade carrier. |
|
|
|
30 SC2660 & SC2672 Skid Steer Rotary Cutter | 1/07/09 |