Table of Contents
Section 5: Maintenance & Lubrication
Land Pride
Land Pride Cutter Blade Parts
Item Part No. Part Description
1
2
2
2
2
3
3
4
4
5
6
Skid Shoe Maintenance
!WARNING
Excessive wear on skid shoes may cause inadequate operation of cutter and create a safety hazard!
Skid shoes should be inspected at the beginning of each cutting season and replaced when material thickness is less than 1/8" at any point. Order only genuine Land Pride parts from your local Land Pride Dealer.
Refer to Figure
3.Remove 3/8" hex lock nuts (#4), lock washers (#5), flat washers (#6), 3/8” plow bolts (#3), three skid shoes (#1) and one skid shoe (#2) from all four deck corners.
4.Plow bolts should be checked for wear and replaced if necessary.
5.Install the new short skid shoe (#2) to the back left deck corner as shown with
6.Install the long skid shoes (#1) to the remaining three deck corners with
7.Raise cutter up and remove support blocks.
Land Pride Standard Skid Shoe Bundle 326-027A
Item Part No. Part Description
1
2
3
4
5
6
Replace skid shoes as follows:
1.Raise the Rotary Cutter 3" or more off the ground and place support blocks under the cutter. Make sure the support blocks are positioned so they will not interfere with skid shoe installation.
2.Lower cutter onto the support blocks, place Skid Steer in park, set park brakes, shut the Skid Steer off and remove switch key.
Land Pride Heavy Skid Shoe Bundle | ||
Item Part No. | Part Description | |
1 | SKID SHOE HEAVY, 3/8" x 3" | |
2 | SKID SHOE HEAVY SHORT, 3/8" x 3" | |
3 | PLOW | |
4 | NUT LOCK | |
5 | WASHER LOCK SPRING 3/8 PLT | |
6 | WASHER FLAT 3/8 SAE PLT |
24546 |
Skid Shoe Replacement
Figure
24 SC2660 & SC2672 Skid Steer Rotary Cutter | 1/07/09 |