Land Pride SC2672, SC2660 manual Height Adjustment Safety Chain

Land Pride

Section 2: Adjustments

Table of Contents

Height Adjustment Safety Chain

!WARNING

Always secure cutter deck in the up position with solid supports or by locking the hydraulics before working around or under a raised deck. Never work under equipment supported by hydraulics. Hydraulics can drop equipment if controls are actuated or if hydraulic lines burst. Either situation can drop the cutter instantly even when power to the hydraulics is shut off.

!DANGER

Do not raise cutter higher than 16 1/2" off the ground. Raising cutter higher can cause serious bodily injury and/or death. Use safety limit chain to limit cutter height.

Refer to Figure 2-2:

For safety, the cutter rear skid shoes should not be raised higher than 16 1/2" off the ground (18" Maximum cutting height).

NOTE: Two people may be required to install and adjust the safety chain.

1.Raise cutter’s rear skid shoes slightly less than 16 1/2" off the ground.

2.Run height adjustment safety chain from under the 2" x 3" hitch tube to the Skid Steer lower hitch loop. Thread chain through the hitch loop and back towards the hitch plate. Connect quick link coupler to a chain loop as shown.

3.Raise cutter up until the safety chain is tight. Check height of rear skid shoes.

!DANGER

Do not tilt hitch plate to raise front of cutter higher than the rear. Raising front of cutter can cause serious bodily injury and/or death.

4.If rear skid shoes are higher than 16 1/2" above ground level, lower cutter and make necessary adjustments to the safety chain to limit rear skid shoe height to

16 1/2" maximum.

5.Tighten quick link coupler nut to secure safety chain.

Ratchet Jack

Bottom of Rear

Skid Shoes

Gauge Wheel

Ground Level

24586

Nominal Cutting Height

Figure 2-2

Cutter Hitch Plate

Quick Link Coupler

Height Adjustment

Safety Chain

16 1/2"

Maximum Lift

Skid Steer

Lower Hitch Loop

1/07/09 SC2660 & SC2672 Skid Steer Rotary Cutter 326-025M 15