Landice 8700 manual Symptom, Is it out of position?, Any found?, Yes

62

SYMPTOM

Display lights up, treadbelt moves,speed will not increase,L5 error.

5.1

5.2

Check speed sensor alignment.

It should be within 1/16" of the flywheel and parallel to the flywheel.

Is it out of position?

NO

Unplug 3 wire speed sensor connector from relay board. Check for pushed pins or loose wires.

Any found?

NO

	Adjust speed sensor:
	1.Use 1/2" wrench and loosen
	the two lock nuts securing
YES
	sensor to it's bracket.
	2.	Adjust sensor gap to 1/16".
	3.	Tighten lock nuts.

Repair or replace speed YES sensor / harness assembly.

Part# 71007

5.3

5.4

Unplug 12 wire upper harness
connector from relay board. Check for
				Repair or replace upper
pushed pins or loose wires. Specifically
			YES
				harness. Part# 70211
look at 8 (White) and 12 (Green).
Any found?
	NO
Is speed control wiring OK?
Purple wire from V+ on pwm board to H on relay board.						Correct speed
Orange wire from P1 on pwm board to L on relay board.					NO
						control wiring.
Brown wire from P2 on pwm board to W on relay board.
P3 on pwm board has no connection.
		YES

Replace the speed sensor. Part # 71007