Configuring the Printer for the Network
2 - 4 Printer Configuration
•You should set up your server, if you want to use “RARP + TFTP”, “BOOTP”, or
“DHCP”.
1. Press the Up or Down Arrow keys
until the following message appears.
2. Press [Enter #].
The current setting appears on the panel
display.
3. Press the Up or Down Arrow keys
until the method you want to use
appears.
4. Press [Enter #].
9If you use NetWare, select the frame type for NetWare.
Select one of the items below if necessary.
•Auto Select (Default)
•Ethernet 802.3
•Ethernet 802.2
•Ethernet II
•Ethernet SNAP
Note: Usually, you can use the default setting (“Auto Select”). With “Auto
Select”, the frame type detected by the printer first is adopted. If your net work can
use more than two frame types, the printer may fail to sel ect the co rr ect fram e
type. In this case, select the appropriate frame type.
1. Press the Up or Down Arrow keys until
the following message appears.
2. Press [Enter #].
None (Default
Setting)
RARP + TFTP X
BOOTP X
RARP & BOOTP X X
DHCP X
Menu item on the
panel display Available method
ARP+ING RARP_TFTP BOOTP DHCP