Configuring the Printer for the Net work
Printer Configuration 2 - 3
TCP/IP, you should assign the IP Address to your printer.
•To get the IP Address for your printer, contact your network administrator.
•The IP Address is shown by Byte on the panel
display.
1. Press the Up or Down Arrow keys until
the following message appears.
2. Press [Enter #].
The current Byte 1 of the IP Address
appears on the panel display.
3. Use the Up or Down Arrow keys to
specify the IP Address.
4. Press [Enter #].
The current Byte 2 of the IP Address
appears.
5. Use the Up or Down Arrow keys to
specify the Byte 2 of the IP Address.
Repeat steps 3 and 4 to specify the rest of the IP Address.
6. Press [Enter #] to register the IP
Address you specified.
6If you use TCP/IP, you should assign the
“Subnet Mask” and “Gateway Address”
following the same procedure for specifying the IP Address.
7If you use TCP/IP, set the “Access Control” and “Access Mask” following the same
procedure for specifying the IP Address, if necessary.
8If you use TCP/IP, you can make settings for “Network Boot”.
•You can select how to assign the printer's address using the computer. Select one of the
items on the following table.
Menu item on the
panel display Available method
ARP+ING RARP_TFTP BOOTP DHCP
ARP + PING <IconSt1>'
ARP & RARP <IconSt1>' <IconSt1>'
ARP & BOOTP <IconSt1>' <IconSt1>'
ARP&RARP&BO
OTP
<IconSt1>' <IconSt1>' <IconSt1>'
01 1 . 022 . 033 . 044
Byte 1 Byte 2 Byte 3 Byte 4