Configuring the Printer for the Network
2 - 2 Printer Configuration
5Select the protocol you want to use. You can select one of the ite ms on the foll owing table.
Note: <IconSt1>' means that this protocol is active.
Blank cell means that this protocol is not active.
You should not select protocols that are not used on your network.
If you want to select AppleTalk, you should install the optional PostScript kit
Type 185.
1. Press the Up or Down Arrow keys until
the following message appears.
2. Press [Enter #].
The current settings appear on the
panel display.
3. Press the Up or Down Arrow keys until
the protocol you want to use appears.
4. Press [Enter #].
The actual procedure may differ depending on the protocol you use. If you use
Menu item on the
panel display Active Protocol
TCP/IP NetWare AppleTalk NetBEUI
All Active
(Default Setting)
XXXX
None
TCP/IP Only X
NetWare Only X
TCP/IP & NetW X X
ATalk Only X
TCP/IP & ATalk X X
NetWare & ATalk X X
TCP & ATK &
NW
XXX
NetBEUI only X
TCP/IP & NB X X
NetBEUI & NetW X X
TCP & NB & NW X X X
NetBEUI & ATalk X X
TCP & NB & ATK X X X
NB & NW &
ATalk
XXX