Lantronix 900-558 Link config-etherneteth0 level commands, Lpd lpd level commands, Kill line

	5: Commands and Levels
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
link (config-ethernet:eth0) level commands
clrscrn	Clears the screen.
default duplex	Restores the default duplex setting, which is auto.
default speed	Restores the default speed setting, which is auto-
	negotiate.
duplex auto	Sets duplex mode to auto.
duplex full	Sets duplex mode to full.
duplex half	Sets duplex mode to half.
exit	Exit back to interface configuration level
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
speed 10	Sets the speed of the Ethernet link to 10 Mbps.
speed 100	Sets the speed of the Ethernet link to 100 Mbps.
speed auto	Sets the speed of the Ethernet link to auto-negotiate.
write	Stores the current configuration in permanent memory.
log (config-diagnostics-log) level commands
clrscrn	Clears the screen.
default max length	Restores the factory default maximum Log file size.
default output	Disables log output.
default severity level	Log all events.
exit	Exits to the next higher level.
max length <Kbytes>	Sets the maximum size in Kbytes for the Log file.
output disable	Enables log to filesystem.
output filesystem	Enables log to serial line.
output line <number>	Could not find VarID 438 entry 3 in file
	http/config/varid_help.mtxt
severity level debug	Log all events.
severity level error	Log only Error and more severe events.
severity level information	Log only Information and more severe events.
severity level notice	Log only Notice and more severe events.
severity level warning	Log only Warning and more severe events.
show	Shows the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
write	Stores the current configuration in permanent memory.
lpd (lpd) level commands
auto show <line>	Continuously displays lpd status for the specified line.
	<line> = LPD line to display.
clrscrn	Clears the screen.
exit	Exits to the enable level.
kill <line>	Kills the current print job on the specified line.
	<line> = LPD line with print job.
show <line>	Displays lpd status for the specified line.
	<line> = LPD line to display.
show history	Displays the last 20 commands entered during the current

XPort Pro Command Reference 104