Leica 106Z user manual Assembly, Observe the safety regulations­ on

Assembly

Lamp housing

The Leica 106Z lamp housing­ is equipped..

For information about the supply units for the 106Z lamp housing, see page 14..

Model 105Z lamp housings, if available, can also be used..

Observe the safety regulations­ on page 5

Notes and recommendations

•Do not switch on and off more than necessary, because this will shorten the burner life

•Hot mercury-vapour burners cannot be ignited again until after they have cooled

•If possible, burn-in new mercury-vapour burners by running them continuously­ for one or two hours

•Be very careful when fitting the burner.

Do not apply pressure, as it breaks easily

•Never touch the glass envelope of the burner with your fin-

gers.. Fingerprints­later burn in and reduce the light quality.. If necessary, carefully remove fingerprints and dust using a

cloth damped with alcohol­ and then wipe dry..

Fitting and changing the mercury-vapour burner

For the l06Z lamp housing, use the 100W mercury-vapour burner type 307-072..057 or the 50W burner..

The mercury-vapour ­burner is supplied in a separate package..

–Units which are unmarked or are marked­ L1 are for lower

currents and higher voltages­ ..

–Units marked L2 are for higher currents and lower voltages (see page 14)..

▶Slacken the two Phillips­ screws

▶Pull the disconnect plug slightly out

without turning it

▶Flip open the cover

▶ Slacken the Phillips screws

▶ Carefully extract the soc- ket, complete

with burner mount and connecting cable

▶Slacken the slit-headed screws

▶Remove the transport peg and keep it for subsequent transport

▶Dispose of old mercury-vapour burners in accordance with environmental regulations..

•When a new mercury-vapour burner is fitted, the inscription on the metal mount must be upright..

▶Carefully insert the mercury-vapour burner into the lower mount

▶For mercury-vapour burners with seal point: Turn these so that the seal point is at the side of the beam path

▶Carefully position the flexible power cable on the upper metal mount of the mercury-vapour burner..

▶ Tighten the upper and lower screws with great care

▶ Introduce the burner mount, complete

with burner, into the rail of the lamp housing..

▶ Tighten the screws

12