Manufacturer information, Responsible for contents | Leica DM750

Manufacturer information

Published in November 2010 by:

Leica Microsystems (Schweiz) AG

Industry Division

Max Schmidheiny Strasse 201

CH-9435 Heerbrugg (Switzerland)

Responsible for contents:

Dietmar Gnass (Product Compliance) Vincent Vaccarelli (Product Management)

In case of questions, please contact the hotline: mqm-hotline@leica-microsystems.com

Leica DM750	Manual	2

Image 2

Leica DM750 manual Manufacturer information, Published in November 2010 by, Responsible for contents

Contents

Leica DM750 Manual Published in November 2010 by Responsible for contentsManufacturer information Chapter overview Contents Safety regulations Safety concept Provide clarity Light bulbsImportant information Explanatory notes Description Safety instructionsImportant Notes Contact address Intended Purpose of the Microscope Place of use So in the instructions For safety and potential hazardsInstructions on use Fungus Transport Rights to any warranty claimsScope of this manual Disposal Dual or detachable eyecups Health risks and dangers of useHealth risks LED Klasse 1 /LED 1 Laser Product Information for the person responsible for the instrument Information for the person responsible for the instrument ϘϘ Remove tough dirt using alcohol or petro- leum ether Cleaning coated parts and plastic partsCleaning glass surfaces Care instructions Maintenance Accessories, maintenance and repairAccessories Repairs and service work Electrical data Fuse ReplacementElectrical data and ambient conditions Environment Leica DM750 Introduction Result if used improperly Unpacking Ready Leica DM750 is available with two Adjustable Condenser CenteringSubstage Illumination Types of Substage Illumination. Identify Tool ϘϘ Allen key Attaching the viewing TubesTools used Leica EZ Viewing Tube integrated eyepieces Leica EZ viewing tube with integrated eyepieces Tightening the captive thumbscrew again Eyepieces Continue with the Eyecups section on Orientation Leica Standard Viewing Tube separated eyepiecesInsert the eyepieces into the tubes Order to help block out ambient room light Installing Objectives section onEyecups Objective nosepiece Installing ObjectivesInstalling Objectives Substage Condenser Installing the Substage CondenserSer needs to be installed Thus roughly centered Set Turning on the microscope Power CordSetting the Illumination Intensity Work Surface With Koehler illumination, tighten Knurled screws Complete Condenser CenteringDelivery package or, for a Leica DM750 Using the Condenser Using the Condenser Prepare to View a Specimen Slide Slide grips hold the slide in place Focusing Standard Viewing Tube with One or Two Focusing Eyepieces Viewing Tube AdjustmentAdjust the eyetubes Leica EZ Viewing Tube On and your adjustments will be minimal Koehler Configuration Condenser focusing knob Koehler Configuration Oil Immersion Technique Oil Immersion Technique Or Disabled and you will not see any blinking Time Delay ShutoffChanging the status of the time delay shutoff No changes in the intensity control Leica DM750 Manual Ready! Set! Go Care of the Microscope Storage and handling General maintenanceInstructions for cleaning Mechanical Maintenance Illumination Troubleshooting Troubleshooting Make sure that a DF objective is being used Phase contrast Dimensions Leica DM750 Manual Leica DM750 Manual Leica DM750 Manual