Symbols used in this operating manual, Light bulbs | Leica dm750 p

Symbols used in this operating manual

Warning of a danger

•This symbol indicates especially impor- tant information that must be read and

complied with.

Failure to comply can cause the following: ϘϘ Hazards to personnel

ϘϘ Functional disturbances or damaged instru- ments

Warning of hazardous electrical voltage This symbol indicates especially impor- tant information that is mandatory to

read and observe.

Failure to comply can cause the following: ϘϘ Hazards to personnel

ϘϘ Functional disturbances or damaged instruments

Danger due to hot surface.

This symbol warns against touching accessible hot surfaces, e.g. those of

light bulbs.

Important information

This symbol indicates additional infor- mation or explanations that intend to

provide clarity.

Explanatory notes

▶▶ This symbol within the text points to addi- tional information and explanations.

Leica DM750 P	Manual	6

Image 6

Leica dm750 p Symbols used in this operating manual, Light bulbs, Important information, Provide clarity

Contents

Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Important information Symbols used in this operating manualLight bulbs Provide clarity Contact address Important NotesDescription EC Declaration of Conformity Place of use Instructions on useIntended use Non-intended use Disposal To any warranty claimsTransport Integration in third-party products Viral infections of the eye Health risks and dangers of useHealth risks Vidual or detachable eyecups Information for the person responsible for the instrument Information for the person responsible for the instrument Care instructions Cleaning coated parts and plastic partsCleaning glass surfaces General instructions Maintenance Accessories, maintenance and repairAccessories Repairs and service work Input 100-240 V, 50/60 Hz, 5 W 3 W LED Fuse ReplacementElectrical data Environment Leica DM750 P Introduction Check the components against the planned configuration Unpacking Get Ready Attaching Analyzer Module or Analyzer/Bertrand Lens Module Tools used Viewing Tube Installing Objectives Substage Condenser Substage Condenser Completely loosen the two thumbscrews on the condenser mount Get Set Basic setup PowerWork Surface Using the Aperture Condenser Objective Setting up Polarized Light Substage condenser in a swing in/outPolarizer Analyzer into position Focusing Focusing Eyepiece. Do not raise or lower the stage to focus Viewing Tube AdjustmentSlot of the right eyetube Slightly, if at all Koehler Set up Koehler Set up Objective Centration ϘϘ Centering keysFocus the polarizing sample Modules Bertrand Lens Operation Image through the eyepiecesYou can now view the conoscopic image through the eyepieces Time Delay Shutoff Changing the status of the time delay shutoffOr Disabled and you will not see any blinking Leica DM750 P Manual Ready! Set! Go Care of the Microscope Hands. There is a handle on the back Is extended General maintenanceGeneral This purpose For two compensators in the rear Should be moistened with solvent, but Lint-free cloth, lens tissue or cotton swabϘϘ It is very important to avoid the excessive Around the lens Mechanical Maintenance Mechanical Maintenance Dimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual