Fuse Replacement, Electrical data, Environment | Leica dm750 p

Electrical data and ambient conditions

Fuse Replacement

Unplug the instrument before changing any fuses. The Leica DM750 P has two fuses, which are located behind the

power cord receptacle.

•Use only fuse type: 5×20 mm, 1 Amp/250V, Quick acting (# 13RFAG30003)

Electrical data

Input: 100-240 V, 50/60 Hz, 5 W (3 W LED)

Environment
Temperature for use	+10 °C … +40 °C

Storage temperature	-20 °C … +52 °C
	+50 °F … +104 °F

Manipulation shock	25 mm on 50 mm hard wood

Transport shock (unpacked)	100 g / 6 ms

Transport shock (packed)	800 mm free fall

Transport vibrations (unpacked)	5–200 Hz / 1.5 g

Atmospheric pressure "in use" and for storage: 500–1060 mBar

Humidity "in use" and for storage:	20–90%

Installation Category II (Overvoltage Category)

Pollution degree 2

Leica DM750 P	Manual	14

Image 14

Leica dm750 p Fuse Replacement, Electrical data, Input 100-240 V, 50/60 Hz, 5 W 3 W LED, Environment, Pollution degree

Contents

Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Important information Symbols used in this operating manualLight bulbs Provide clarity Contact address Important NotesDescription EC Declaration of Conformity Place of use Instructions on useIntended use Non-intended use Disposal To any warranty claimsTransport Integration in third-party products Viral infections of the eye Health risks and dangers of useHealth risks Vidual or detachable eyecups Information for the person responsible for the instrument Information for the person responsible for the instrument Care instructions Cleaning coated parts and plastic partsCleaning glass surfaces General instructions Maintenance Accessories, maintenance and repairAccessories Repairs and service work Input 100-240 V, 50/60 Hz, 5 W 3 W LED Fuse ReplacementElectrical data Environment Leica DM750 P Introduction Check the components against the planned configuration Unpacking Get Ready Attaching Analyzer Module or Analyzer/Bertrand Lens Module Tools used Viewing Tube Installing Objectives Substage Condenser Substage Condenser Completely loosen the two thumbscrews on the condenser mount Get Set Work Surface Basic setupPower Using the Aperture Condenser Objective Polarizer Setting up Polarized LightSubstage condenser in a swing in/out Analyzer into position Focusing Focusing Eyepiece. Do not raise or lower the stage to focus Viewing Tube AdjustmentSlot of the right eyetube Slightly, if at all Koehler Set up Koehler Set up Focus the polarizing sample Objective CentrationϘϘ Centering keys Modules You can now view the conoscopic image through the eyepieces Bertrand Lens OperationImage through the eyepieces Or Disabled and you will not see any blinking Time Delay ShutoffChanging the status of the time delay shutoff Leica DM750 P Manual Ready! Set! Go Care of the Microscope Hands. There is a handle on the back Is extended General maintenanceGeneral This purpose For two compensators in the rear Should be moistened with solvent, but Lint-free cloth, lens tissue or cotton swabϘϘ It is very important to avoid the excessive Around the lens Mechanical Maintenance Mechanical Maintenance Dimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual