Note: Supply wires may be alternatively connected to the outlet using the screw terminals, however the black supply wire must be wired to a terminal that is opposite (across the outlet) the point where the white supply wire is connected (Figure 15 ).
Green Wire Ground
Connection
White (Supply)
120Vac
60 Hz
120 Vac
60 Hz |
|
Red | Bipolar |
(Supply) | Terminal |
| Screw |
120Vac
60 Hz
Black (Supply)
Figure 15
Gas Flex Line (provided)
Gas Valve
1/2" x 3/8" Flare(Millivolt or Electronic)
Gas Stub
3/8" NPT Flare
3/8" Flex TubingFitting (Remove
Before Hard Piping)
Figure 16
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
CAUTION: NEVER LOCATE INLET OF AN OUT- SIDE AIR HOOD WHERE IT CAN BE BLOCKED BY SHRUBS, SNOW DRIFTS, ETC. NEVER LOCATE INLET IN GARAGE OR ANY AREA WHERE THERE IS ANOTHER FUEL BURNING APPLIANCE OR PRODUCTS EMITTING COM- BUSTIBLE GASES SUCH AS PAINT, GASO- LINE, ETC. IN COLD CLIMATES, IT IS REC- OMMENDED THE COMBUSTION AIR DUCT BE INSULATED.
Outside combustion air ducting may be run upwards or vertically through framing and ceiling joists, with the hood installed through an outside wall and 3' (1 m) below the termi- nation. Ducting may also be run downward through floor joists and under the home to a ventilated crawlspace not considered part of the living area of the home.
After installing the outside air kit, remove the cover from the shut off lever in the left side of the firebox opening.
Note: Do not terminate combustion air kit in attic space under any circumstances.
After completing the installation of the op- tional combustion air vent system the actuator arm must be put in service and tested to ensure proper operation before completing any enclosure around the firebox. Failure to do so may result in extensive and costly rework.
Operate the actuator through several cycles including the closed position. Ensuring proper operation and freedom of movement. Return the actuator arm to the closed position.
Step 8. Installing Logs and Rockwool – The
logs are packaged within the firebox. Remove the rockwool from the packaging and tear into dime size pieces (see Homeowners Care and Operation Instructions). Do not use more than is necessary.
Displace Lava Rock to the center of the burner pan when removing and reinstalling the burner tube.
9