4.Place one washer on each stud. Using a 3/8” nut driver, snug up the nuts on each piece of trim. Do not finish tightening the nuts yet. See Figure 27.

5.Thereshouldbeapproximatelya7/8”(22mm)gapbetween the top edge of the upper trim and the top edge of the door and a 1-1/2” (38mm) gap between the bottom trim to the bottom of the door. Visually inspect the alignment of the trim and adjust if necessary. See Figure 28.

6.Finish tightening nuts. CAUTION-DONOTOVER-TIGHTEN

NUTS, DIMPLING OF THE TRIM WILL OCCUR!!!

Figure 28

Figure 27

12

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.