Brick Panel Installation

Option: Part #79030

Kit Contents:

-Brick Panel (A)

-4 Tap Tights (B)

Tools Required:

-Drill (90° drill recommended)

-#18 drill bit

-5/32 allen wrench

2.Remove all pellets and ash from the firebox to ensure a proper fit for the brick panel.

3.Insert the brick panel, top first, as shown in Figure 35. The two cut out corners should be at the bottom.

A

Figure 33

B

 

Note: The brick panel comes pre-painted with Metallic Black paint. The brick panel may be painted with any color of Stove Bright® high-temp paint (paint may discolor with use).

1.Remove the front door of the pellet stove. To remove the front door, open the two side panels, swing open the front door, and lift it up and off of its hinges. Remove the optional log set, if present, and the burn pot.

Figure 35

4.Make sure that the brick panel is centered, with equal space on either side of the auger tube. While holding the panel in place, use the drill with a #18 drill bit to drill out the four holes in the back of the firebox, as shown in Figure 36.

Figure 36

Figure 34

14

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.