Test gauge connections are provided on the front of the millivolt gas control valve, identified IN for the inlet and OUT for the manifold side (see Fig- urex 2 on Pagex 4 ). A 1/8" NPT Test gauge con- nection is provided at the inlet and outlet side of the electronic gas control valve (see Figurex 3 on Pagex 5).
These appliances must be isolated from the gas supply piping system (by closing their individual manual
These appliances and their individual
Orifice Sizes - Sea Level to High Altitude (All Models)
These appliances are tested and approved for installations at elevations of
Note: Derated (definition) - Replacing burner orifice with a smaller one to reduce BTU input. The installation of this appliance must be accord- ing to the regulations of the local authorities having jurisdiction and, in the USA, the National Fuel Gas Code NFPA 54 / ANSI Z223.1 - latest edition or, in Canada, the
Burner Orifice Sizes (all models)
Elevation | Natural | Propane | |
Gas | Gas | ||
Feet (meters) | |||
drill size (inches) | drill size (inches) | ||
| |||
|
|
| |
#37 (.104") * | 1.55 mm (.061")* | ||
24M1001 • | 42M7901 • | ||
|
|
|
*Standard size installed at factory
• Part /Cat. Number
Table 6
Burn-in Period
During the first few fires of this appliance there will be some odor due to the curing of paint and burning off of lubricants used in the manufacturing process.
Depending on your use, the
KEEP YOUR HOUSE WELL VENTILATED DURING THE CURING PROCESS. THE ODOR AND HAZE EMITTED BY THE CURING PROCESS CAN BE QUITE NOTICEABLE AND MAY SET OFF A SMOKE DETECTOR.
A white film may develop on the glass front during the first few fires as part of the curing process. The glass should be kept clean during the first two weeks of use to prevent the film from baking on (making it very difficult to remove). See Glass Cleaning on Page 8.
SAFETY & WARNIING INFORMATION
WARNING
If the information in this manual is not followed exactly,a fireorexplosion may result causing prop- erty damage, personal injury or loss of life.
WARNING
Failure to comply with the instal- lation and operating instructions provided in this document will result in an improperly installed and operating appliance, voiding its warranty. Any change to this appliance and/or its operating controls is dangerous. Improper installation or use of this appli- ance can cause serious injury or death from fire, burns, explosion or carbon monoxide poisoning.
IMPORTANT
These appliances must not be connected to a chimney or flue serving a separate solid fuel burning appliance.
WARNING
Do not use these appliances if any part has been under water. Immediately call a qualified, professional service technician to inspect the appliances and to replace any parts of the control system and any gas controls which have been under water.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
WARNING
Do not attempt to alter or modify the construction of the appli- ance or its components. Any modification or alteration may void the warranty, certification and listings of this unit.
WARNING
Improper installation, adjust- ment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information consult a qualified installer, service agency or the gas supplier.
WARNING
These fireplaces are vented heaters. Do not burn wood or other material in these appli- ances.
WARNING
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used.
WARNING
Children and adults should be alerted to the hazards of high surface temperatures. Use caution around the appliance to avoid burns or clothing igni- tion. Young children should be carefully supervised when they are in the same room as the appliance.
Note: An Optional Screen Heat Guard for the glass is available (see Page 15 for ordering infor- mation).
3
