Lennox International Inc MPB35ST-NM manual READ LOG WARNINGS ON PAGE 9 BEFORE PROCEEDING

READ LOG WARNINGS ON PAGE 9 BEFORE PROCEEDING

1.Remove front glass enclosure panel from appliance.

a.Open Control Compartment Access Panel (see Control Compart- ment Access Instructions on Page 4.

b.Remove the glass panel enclosure (see Removing Glass Enclosure Panel instructions on Page 9.

2.Remove the following from firebox; log set, embers (rockwool) and vermiculite. Handle logs carefully to prevent breakage.

3. Ensure the Grate is properly installed in the firebox with the 4 legs of the grate fitting into the 4 dimples on the firebox floor.

4.InstallVermiculite-Place some vermiculite on the firebox floor around the grate (the entire bag of vermiculite will NOT be used). See Figure 15 on Page 13. DO NOT PLACE ANY VERMICULITE ON THE BURNER.

6.Placement of Glowing Embers -

Separate the Embers (rockwool) into pieces about the size of a quarter (see Figure 7 ). Keep the pieces fluffed up, not matted. Distribute these pieces over the surface of the burner, as shown in Figure 8. Do not use more than is necessary. Ensure that the main burner ports remain uncovered by the ember material.

Note: This appliance is provided with enough Glowing Embers for several applications, do not use all that is in a new bag at one time. For best glowing effect, replace the ember material annually. Replacement Glowing Embers are available (order Catalog Number 88L53).

Place Embers on burner as shown.

Figure 8	DO NOT PLACE EMBERS OVER
	GAS PORTS / AREAS CIRCLED

7.Place Log (A) on the grate as shown in Figure 9

A

Position Groove At The Bottom Of	Position The Groove At The Bottom Of
	Log (A) Over The Grate And Slide It
Log (A) Over The Log Support Here
	Forward Against The Grate Here

(Valve Access Side)

Figure 9

8.Place Log (B) as shown in Figure 10.

	Position Log (B) Against The Back Of
B	The Grate Here
	Position Groove at The Bottom Of Log (B) Over The Grate
	Here And Slide It Against The Back Of The Grate
Figure 10	(Valve Access Side)

9.Place Log (C) as shown in Figure 11.

Log (C) Lays Over Logs (A) and (B)

B

A

C	(Valve Access Side)
	Position The Groove in The Back of Log (C)
Figure 11	Against The Grate

10.Place Log (D) as shown in Figure 12.

Position And Slide Log (D) Against The

Back Of The Grate

A

	D
(Valve Access Side)	Place Log (D) Over The
	Flat Spot On Log (A) Here

Figure 12

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

9