Lenovo 4011, 1044, 4010, 1043 manual Microprocessor problems

•See the parts listing in the Hardware Maintenance Manual to determine which components are customer replaceable units (CRUs) and which components are field replaceable units (FRUs).

•If an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

Symptom	Action
The amount of system memory	1. Make sure that:
that is displayed is less than		• No error LEDs are lit on the operator information panel or on the DIMM.
the amount of installed physical
		• Memory mirroring does not account for the discrepancy.
memory.
		• The memory modules are seated correctly.
		• You have installed the correct type of memory.
		• If you changed the memory, you updated the memory configuration in the
		Setup Utility program.
		• All banks of memory are enabled. The server might have automatically
		disabled a memory bank when it detected a problem, or a memory bank
		might have been manually disabled.
	2.	Check the POST event log for DIMM error messages:
		• If a DIMM was disabled by a systems-management interrupt (SMI), replace
		the DIMM.
		• If a DIMM was disabled by the user or by POST, run the Setup Utility program
		and enable the DIMM.
	3.	Make sure that there is no memory mismatch when the server is at the minimum
		memory configuration.
	4.	Add one pair of DIMMs at a time, making sure that the DIMMs in each pair
		are matching.
	5.	Reseat the DIMMs.
	6.	Replace the DIMMs one at a time in the order and restart the server each time.
Multiple rows of DIMMs in a	1. Reseat the DIMMs; then, restart the server.
branch are identified as failing.	2.	Replace the lowest-numbered DIMMs with identical known good DIMMs;
		then, restart the server. Repeat as necessary. If the failures continue after all
		identified pairs are replaced, contact a trained service technician for help.
	3.	Return the removed DIMMs, one pair at a time, to their original connectors,
		restarting the server after each pair, until a pair fails. Replace each DIMM in
		the failed pair with an identical known good DIMM, restarting the server after
		you reinstall each DIMM. Replace the failed DIMM. Repeat these actions until
		you have tested all removed DIMMs.
	4.	(Trained service technician only) Replace the system board.

Microprocessor problems

•Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

•See the parts listing in the Hardware Maintenance Manual to determine which components are customer replaceable units (CRUs) and which components are field replaceable units (FRUs).

•If an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

86ThinkServer Installation and User Guide