Command Function
H1 Force modem off-hook (make busy)
Note: H1 command is not supported for Italy

I_ I0 Display product-identification code

I1 Factory ROM checksum test
I2 Internal memory test
I3 Firmware ID
I4 Reserved ID

L_ L0 Low speaker volume

L1 Low speaker volume
L2 Medium speaker volume
L3 High speaker volume

M_ M0 Internal speaker off

M1 Internal speaker on until carrier detected
M2 Internal speaker always on
M3 Internal speaker on until carrier detected and
off while dialing

N_ Included for compatibility only, provides no

effect

O_ O0 Return to Data Mode

O1 Return to Data Mode and initiate an equalizer
retrain

P Set Pulse dial as default

Q_ Q0 Modem sends responses

Sr? Read and display value in register r.

Sr=n Set register r to value n (n = 0-255).

T Set Tone Dial as default

V_ V0 Numeric responses
V1 Word responses
W_ W0 Report DTE speed only
W1 Report line speed, error correction protocol,
and DTE speed.
W2 Report DCE speed only

X_ X0 Hayes Smartmodem 300 compatible

responses/blind dialing.
X1 Same as X0 plus all CONNECT
responses/blind dialing
X2 Same as X1 plus dial tone detection
X3 Same as X1 plus busy detection/blind dialing

X4 All responses and dial tone and busy signal

detection

Z_ Z0 Reset and retrieve active profile 0

Z1 Reset and retrieve active profile 1

64 User Guide