Starting and shutting down the projector
1.Connect the power cord to the projector. Connect the other end to a wall outlet. This turns on the POWER and READY LEDs on the projector.
2.Turn on the connected devices.
3.Ensure that the Ready LED is on a steady (not flashing) orange and then press the Power button to turn on the projector. The projector splash screen displays and connected devices are detected. If the connected device is a PC, press the appropriate keys on the computer keyboard to switch the display output to the projector. (Check the user manual of the PC to determine the appropriate Fn key combination to change display output). See ″Navigating the OSD on “Navigating the OSD” on page
4.If more than one input device is connected, press the Source button repeatedly to switch among devices. DVI and component video are supported through the
5.To turn off the projector, press the Power button. The projector prepares for shutdown and a ″Wait a moment please...″ message appears.
6.When the ″Power Off?/Press Power again″ message appears, press the Power button. The projector turns off.
Note: This projector has a fast shutdown cycle to let you unplug the projector. However, to allow proper cooling of the bulb, the projector will not turn on again for 60 seconds.
Attention: Do not unplug the power cord until the Ready LED stops flashing, indicating the projector has cooled down.
Chapter 2. Setup and Operation
