Lenovo T41/T41P, T42/T42P manual Press F9, and Enter to

		Symptom-to-FRU index
Symptom or error	FRU or action, in sequence
0185	1.	Run BIOS Setup Utility.
Bad startup sequence settings.		Press F9, and Enter to
Enter BIOS Setup and load		load the default setting.
Setup defaults.		Then save the current
		setting by pressing F10.
0187	System board.
EAIA data access error—The
access to EEPROM is failed.
0188	System board.
Invalid RFID Serialization
Information Area.
0189	System board.
Invalid RFID configuration
information area—The
EEPROM checksum is not
correct.
0190	1.	Charge the battery pack.
Critical low-battery error	2.	Battery pack.
0191	1.	Run BIOS Setup Utility,
System Security—Invalid		and then save current
Remote Change requested.		setting by pressing F10.
	2.	System board.
0192	System board.
System Security— IBM
Embedded Security hardware
tamper detected.
0199	1.	Run BIOS Setup Utility,
System Security—IBM Security		and then save the current
password retry count exceeded.		setting by pressing F10.
	2.	System board.
01C8	1.	Remove either a Mini-PCI
Two or more modem devices		Card or a modem
are found. Remove all but one		daughter card. Otherwise,
of them. Press <Esc> to		press Esc to ignore the
continue.
		warning message.
	2.	System board.
01C9	1.	Remove the Ethernet
More than one Ethernet devices		device that you installed;
are found. Remove one of		or press Esc to ignore the
them. Press <Esc> to continue.		warning message.
	2.	System board.
0200	1.	Reseat the hard disk
Hard disk error—The hard disk		drive.
is not working.	2.	Load Setup Defaults in
		BIOS Setup Utility.
	3.	Hard disk drive.
	4.	System board.
021x	Run interactive tests of the
Keyboard error.	keyboard and the auxiliary
	input device.

ThinkPad T40/T40p, T41/T41p, T42/T42p Series 59