Loading paper | 31 |
4Open the control panel cover to access layer 2.
1 | 2 | 3 | 4 |
Power
Set TOF | LineFeed | Macro |
Micro | Micro | Setup |
Pitch | 10 | 20 |
|
| |
| 12 | 24 |
| 15 |
|
Lock | 17 |
|
5Press any paper movement button (Micro 
, Micro with the Top‑Of‑Form you want.
, LineFeed) to align the horizontal lines located on the platen
Note: If you press and hold a paper movement button, the paper will advance in micro movements and then go into continuous feed mode.
6Press Set TOF to set and save your Top‑Of‑Form.
7Close the control panel cover.
8Press Start/Stop to put the printer online.
Setting Top‑Of‑Form in a macro
Each macro has a separate Top‑Of‑Form setting. To set Top‑Of‑Form in a macro, you must first select that macro.
1Open the control panel cover to access layer 2.
2Press Macro to select the macro you want to use.
Note: The procedure for setting Top‑Of‑Form depends on the paper and print mode you are using. For help, see one of the following sections in this chapter:
•“Setting Top‑Of‑Form for continuous forms in push mode” on page 29
•“Setting Top‑Of‑Form for continuous forms in pull mode” on page 30
•“Setting Top‑Of‑Form for a cut form or an envelope” on page 30
