2Choose the correct control panel for your language.
3Align the clips on the control panel with the holes on the printer, and then press down.
Getting the printer ready to fax

Choosing a fax connection

You can connect the printer with equipment such as a telephone, an answering machine, or a computer modem. If
problems occur, see “Setup troubleshooting” on page 75.
Note: The printer is an analog device that works best when directly connected to the wall jack. Other devices (such
as a telephone or answering machine) can be successfully attached to pass through the printer, as described in the
setup steps. If you want a digital connection such as ISDN, DSL, or ADSL, a third-party device (such as a DSL filter)
is required.
You do not need to attach the printer to a computer, but you do need to connect it to a telephone line to send and
receive faxes.
You can connect the printer to other equipment. See the following table to determine the best way to set up the
printer.
Equipment Benefits See this section
The printer
A telephone cord
Send and receive faxes without using a
computer. “Connecting directly to a telephone
wall jack” on page 13
The printer
A telephone
Two telephone cords
Use the fax line as a normal telephone
line.
Send and receive faxes without using a
computer.
“Connecting to a telephone” on
page 13
The printer
A telephone
An answering machine
Three telephone cords
Receive both incoming voice messages and
faxes. “Connecting to an answering
machine” on page 14
The printer
A telephone
A computer modem
Three telephone cords
Send faxes using the computer or the
printer. “Connecting to a computer with a
modem” on page 16
12