![](/images/new-backgrounds/1172443/17244367x1.webp)
Setting up the printer to fax | 34 |
•If you need two phone ports for your devices but do not want to pay extra, then do not plug the printer into the second phone port. You can use a phone splitter. Plug the phone splitter into the Phone Line 1 or Phone Port , and then plug the printer and telephone into the splitter.
Make sure you use a phone splitter, not a line splitter. To make sure that you are using the correct splitter, plug an analog telephone into the splitter and then listen for a dial tone.
Setup 2: Printer is connected to a wall jack; cable modem is installed elsewhere in the house
Follow this setup if your cable provider activated the wall jacks in your house so that you do not have to plug your devices into the cable modem. Your cable telephone service comes from the wall jacks.
To connect:
1Connect the cable from the wall jack to the port of the printer.
2Remove the protective plug from the port of the printer, and then connect the telephone to the port.
Scenario 5: Country‑ or region‑specific setup
Different countries or regions have different types of telephone wall jacks. The standard wall jack adopted by most countries or regions is the Registered
The fax ports on the back of the printer and the telephone cable that comes with the printer have RJ‑11 connectors. If you have a different type of connector in your country or region, then you may need to use an RJ‑11 adapter.