Troubleshooting | 44 |
CHECK THE USB CONNECTION
1Check the USB cable for any obvious damage. If the cable is damaged, then use a new one.
2Firmly plug the square end of the USB cable into the back of the printer.
3Firmly plug the rectangular end of the USB cable into the USB port of the computer.
The USB port is marked with 
.
Note: If you continue to have problems, then try another USB port on the computer. You may have connected to a defective port.
RECONNECT THE PRINTER POWER SUPPLY
1Turn off the printer.
Note: Make sure the printer is not in Sleep mode. Press and hold 
for three seconds to turn off the printer.
2Unplug the power cord from the wall outlet, and then pull out the power cord from the power supply.
3After one minute, reconnect the power cord into the power supply, and then plug the power cord into the wall outlet.
4Turn on the printer.
Print job does not print or is missing pages
If the "Before you troubleshoot" checklist does not solve the problem, then try one or more of the following:
MAKE SURE THE INK CARTRIDGES ARE INSERTED CORRECTLY
1Turn the printer on, and then open the printer.
2Make sure the cartridges are inserted correctly.
The cartridges should click firmly into the matching color slot of the printhead.
3Close the printer.
SELECT YOUR PRINTER FROM THE PRINT DIALOG BEFORE SENDING THE PRINT JOB
Note: This solution applies to Macintosh users only.
1With a document open, choose File > Print.
2From the printer
If your printer does not appear in the Printer list, then choose Add Printer. From the list of printers in the Default tab, select your printer, and then click Add.
If your printer does not appear in the list, then try either of the following:
•For a
•For a printer that is wirelessly connected, see the Wireless troubleshooting section.
MAKE SURE THE PRINT JOB IS NOT PAUSED
MAKE SURE YOUR PRINTER IS SET AS THE DEFAULT PRINTER
RECONNECT THE PRINTER POWER SUPPLY
1Turn off the printer.
Note: Make sure the printer is not in Sleep mode. Press and hold 
for three seconds to turn off the printer.
2Unplug the power cord from the wall outlet, and then pull out the power cord from the power supply.
3After one minute, reconnect the power cord into the power supply, and then plug the power cord into the wall outlet.
4Turn on the printer.
REMOVE AND RECONNECT THE USB CABLE CONNECTED TO YOUR PRINTER
CHECK THE USB CONNECTION
1Check the USB cable for any obvious damage. If the cable is damaged, then use a new one.
2Firmly plug the square end of the USB cable into the back of the printer.
3Firmly plug the rectangular end of the USB cable into the USB port of the computer.
The USB port is marked with 
.
Note: If you continue to have problems, then try another USB port on the computer. You may have connected to a defective port.
REMOVE AND REINSTALL THE PRINTER SOFTWARE
Printer is printing blank pages
Blank pages may be caused by improperly installed ink cartridges.
REINSTALL THE INK CARTRIDGES AND DEEP CLEAN AND ALIGN THE PRINTHEAD
1Reinstall the ink cartridges, see “Replacing ink cartridges” on page 16 for more information.
