3.2 SUGGESTED TOOL REQUIREMENTS
SCREWDRIVER(+,
3.2.1 PREPARATION OF SLEEVE
SLEEVE HARDWARE
12
14
NUMBER | NAME OF PARTS | Q’TY | 1 |
| SLEEVE LOWER | 1 |
|
| SLEEVE UPPER | 1 |
|
| SCREW | 4 |
|
| OUTDOOR GRILLE | 1 |
|
| DRAIN KIT | 1 |
|
ASSEMBLE THE WALL SLEEVE
• Raise the sleeve side panels to upright position as shown on the right.
• Place sleeve upper on top of side panels.
• Fasten the four screws as shown on the right.
• Assemble drain kit.
• Fasten this assembly to the each side of the wall sleeve as shown on the right.
• Assemble the outdoor grille and fasten the 4 screws as shown on the right.
3.2.2 PREPARATION OF THE FRONT GRILLE
Carefully remove shipping tape, if there is any, from the front grille.
Shipping tape
