LG Electronics 230/208V service manual Power Cord, 6 P.C.B

2.3.5 POWER CORD

1.Remove the control box. (Refer to section 2.1.2)

2.Disconnect the grounding screw from the control box.

3.Disconnect 2 receptacles.

4.Remove a screw which fastens the clip cord.

5.Separate the power cord from the control box. (See Fig. 12)

6.Re-install the component by referring to the removal procedure, above.

(Use only one ground-marked hole for ground connection.)

7.If the supply cord of this appliance is damaged, it must be replaced by the special cord.

(The special cord means the cord which has the	Figure 12
same specification marked on the supply cord
fitted to the unit.)

2.3.6 P.C.B.

1.Remove the escutcheon.

2.Remove the two knobs.

3.Remove the 2 screws which fasten P.C.B. cover.

4.Disconnect all the leads which connected to the P.C.B.

5.Remove the two screws which fasten the P.C.B. board.

6.Re-install the components by referring to the removal procedure, above.

Figure 13

—13—