Commercial Mode Setup for Master TV
This section describes how to set up a Master TV for cloning purposes when the TV is in
Note: Disconnect all Aux inputs. Under certain conditions, Auto Tuning (Channel Search) is disabled if there is an Aux input active.
Note: Refer to FTG Mode information on pages 29 to 37 for information on entering FTG Mode and config- uring/editing FTG Channel Map and FTG Installer Menu settings using the FTG Configuration Application.
1.Set Installer Menu items.
This step provides specific instruction only on the Installer Menu items that should be set on a Master TV. Refer to pages 14 to 20 for detailed information on all Installer Menu items.
a)Make sure the TV is ON. Then, use the Installer Remote to enter the TV Installer Menu: Press MENU repeatedly until the
ENTER.
b)Set Installer Menu item 117 FACT DEFAULT to 001 and press ENTER on the Installer Remote.
This clears all Installer Menu custom settings, the channel lineup, etc. and reloads the factory default settings. The value will change back to 0 after the internal TV controller (Protocol Translator Card [PTC]) has been restored to factory default condition. This step ensures that the TV Channel Memory will be the active channel lineup.
c)Set Installer Menu item 003 BAND/AFC, as appropriate.
• | Broadcast: Set to | 000. | • | HRC: Set to 002. |
• | CATV: Set to 001 | (default). | • | IRC: Set to 003. |
d)Set any other Installer Menu items that affect your TV program- ming network to the required configuration. For example, enable/ disable Aux sources, set a Start Channel, etc.
e)After you have adjusted all required Installer Menu item settings, press ENTER once on the Installer Remote to save your changes; then, press ENTER again to exit the menu.
2.Set up TV features.
Note: If desired, you can run Auto Tuning (see step 3) prior to completing this step.
3.Run Auto Tuning (Channel Search).
xxLD330H PTC INSTALLER MENU
000 | INSTALLER SEQ | 000 |
|
|
|
UPN | ASIC 20E7 | |
PTC | V1.00.001 | CPU V3.06.00 |
|
|
|
Typical TV Installer Menu
Note: The Installer Menu header will vary depending on the TV you are setting up.
117 | FACT DEFAULT | 001 |
003 | BAND/AFC | 00X |
Adjust the settings for these
Installer Menu items.
CHANNEL | PICTURE | AUDIO | TIME |
LOCK | OPTION | INPUT | MY MEDIA |
Set the TV features to the desired
configuration for the end user.
a)Search for all available analog and digital channels: Go to the Channel Menu, select the Auto Tuning option, and follow the
(Continued on next page)
12 |
