Cloning Connections/Learning Setup
Connections for the LT2002 Clone Programmer to Learn the TV Master TV Setup
Antenna
or CATV
Warning: Do not use LT2002 while any PPV card is installed in TV or clone programmer device
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION | XX | |
THE TV IS VERSION | XX | |
THE SW IS REVISION | XX | |
CLONE CLOCK | = XX:XX |
|
TV CLOCK | = XX:XX |
|
Ferrite Core (TDK, ZCAT
Connect cable to |
|
|
|
|
TV MPI Jack and |
|
| Status | |
follow on screen |
|
| ||
instructions |
| Indicator | ||
|
|
|
|
|
MPI
Reset
Color | |
• green | battery ok |
• red | battery low |
Blink pattern | |
• slow | power on |
| no communications |
• heartbeat | power on |
| communications ok |
® |
|
QuickSet II Programmer
LT2002
ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS USA
will be damaged.
Master TV
Clone Programmer
Notes: It is assumed that the TV is connected to a signal source, the source selected is Antenna (RF) In, the signal is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, see above and next page.
Before you begin cloning...
•The Master TV should be connected to a good, stable signal from an
•Teaching and Learning is only possible between identical model devices. (However, the LT2002 Clone programmer can store up to 3 different ‘master’ setups.)
WARNING: Copying a blank or incorrect memory into a TV, STB or other device will cause the TV, STB or other device to operate erratically or become inoperable.
•Use an Installer’s remote to operate Learning and Teaching menus.
•Make sure that the batteries in the Clone programmer are fresh.
•If batteries are removed, the Clone Clock time will be lost.
•Decide if you want to set the time from the Clone program- mer or copy the time to the Clone programmer; from a com- patible TV which has the clock set to the current time.
•Setting the time and transferring it to the Clone or other device is a separate procedure.
•Follow the connection diagram above to connect the Clone to a Master TV TV display panel. After learning is complete, to another identical TV TV display panel to “teach” it the master setup.
•See the Clone Troubleshooting section to resolve problems.
Turn to the next page to continue Cloning Setup.
P A G E 7 |
