4.LCD PANEL DESCRIPTION
4.1Turning Power On and Starting Instrument
Connect the accessory power cord between the AC inlet on the rear panel and the mains. Press the POWER switch to turn power on for starting the system. Whit for about 45 seconds until the top screen (Status screen) is displayed. The setting conditions immediately before turning power off will be recalled.
4.2Screen Description
The screen display consists of the top screen and various setting screens. The followings describe the typical screens.
<Top Screen>
| ○ | |
○ | 3 | |
1 |
| |
○ |
| |
2 | ○ | |
5 | ||
○ | 4 | |
9 | ||
○ | ○ | |
6 | ○ | |
○ | 10 | |
| ||
7 |
| |
○ | 11 | |
8 | ○ | |
○ | ||
| ||
12 | ○ | |
| ||
| 13 |
|
| Figure |
1 | Screen title | Indicate the top (Status) screen. |
2 | Unit information | Indicate the setting parameter of this instrument or OOB. |
3 | Group | Displays the preset group number. |
4 | TS signal selection | Selects the TS to be used. |
5 | Carrier modulation (Current) | Displays the carrier modulation setting status. |
6 | Channel, frequency | Displays the channel number when the RF signal is set in |
|
| channel. |
|
| Displays the frequency in units of MHz when the RF |
|
| signal is set in frequency. |
7 | Output level | Displays the output level. |