8.12 Detail Program Code
This section describes the detail program codes listed in Section 8.11. Definition:
n, p, q, r, s i
ne
_
•Terminator is omitted for a syntax. Add the terminator at the end of the code (refer to Section 8.9).
•Header is not added for reply; the reply code consists of data only.
(1)Selecting modulation mode..................."SY"
Function | Selecting and querying modulation mode. | ||
Syntax | SY_n | (Setting, reply) | |
| SY_? | (Query) | |
|
|
| |
n | Modulation Mode Selection |
08VSB
164QAM
2256QAM
(2)Selecting TS input................................."TS"
Function | Selecting and querying TS for channel coding. |
Syntax | TS_n (, p, q, r) (Setting, reply) |
TS_? | (Query) |
*In this program code, the amount of consequent data depends on "n" selected.
n | TS Input Selection |
0 | PN |
1 | External ASI |
2 | External SPI |
3 | Internal (OP70) |
4 | Reserve (Not used) |
5 | ROM |
*"3" is only enabled when the Moving Picture Option (OP70) is installed.
For external ASI or external SPI
p | TS Type Selection |
0
1Reserve (Not used)