USB Cloning Procedures (Cont.)

Teach Master TV Setup to Target TV

1.Turn ON the Target TV.

The next step depends on whether the Express Script Installer Menu Wizard appears on the screen:

•If the wizard is displayed, the TV is in the required factory default state. Use the Up/Down arrow keys on the Installer Remote to select Exit, and then press OK to exit the wizard. Then, go to step 3.

•Otherwise, ensure the Target TV is in Pass-through Mode, and then continue with step 2.

Note: If the Master TV Setup contains a TV Zone # assignment, in order for the proper location-specific TV Zone profile data to be applied, you will need to assign the same Zone designation in the Target TV(s) BEFORE Teaching is performed. Refer to Reference section, “Using the TV Zoning Feature,” for further information.

2.Use the Installer Remote to access the Target TV Installer Menu (see “Accessing the Installer Menu” on page 15 for further information). Set Installer Menu item 117 FACT DEFAULT to 1, and press OK. When the value changes back to 0, press OK again to exit the Installer Menu.

Note: This step restores factory default settings on the TV, which will in turn re-activate the Express Script. Exit the wizard (see step 1); if applicable, set the TV Zone # (see note above); and then continue with step 3.

3.Insert the USB memory device with the .tlx file into the Target TV USB IN port.

4.Press MENU on the Installer Remote to display the TV setup menus. Use the arrow navigation keys to select/highlight the Option menu icon, and then press the number “7” key a total of seven times to display the USB Download Menu.

5.Use the Up/Down arrow keys to select Teach To TV (TLX), and then press OK.

6.Use the Up/Down arrow keys to select the Master TV Setup you want to install, and then press OK. Note: Filenames identify the TV and the TLX version (see example at right).

Teaching status will be shown on a progress bar in a new window. When the Teaching process is complete, the TV will briefly display a “Teaching Completed” window and then exit the USB Download Menu.

7.Remove the USB memory device from the Target TV, and verify that the Master TV Setup is now resident on the Target TV.

Note: After the Teaching process is complete, the TV tunes according to the setting of Installer Menu item 004 STRT CHANNEL (Start Channel). If a Start Channel is specified, the TV will tune to that channel; otherwise, the TV will return to the last channel tuned.

USB Download Menu

Upgrade TV Software

Upgrade PTC Software

Teach To TV (TLL)

Teach To TV (TLX)

CC / Previous

OK

Teach To TV (TLX)

42LQ640H-UA00003.TLX

CC / Previous

OK

Teach To TV

UPDATING...

50%

Do not unplug!

36

206-4245