LG Electronics 42WS50MS, 47WS50MS owner manual Mounting on a wall

12ASSEMBLING AND PREPARING

ENGLISH

Mounting on a wall

For proper ventilation, allow a clearance of 10 cm on each side and from the wall. Detailed installation instructions are available from your dealer, see the optional Tilt Wall Mounting Bracket Installation and Setup Guide.

10 cm

10 cm

10 cm 10 cm

10 cm

CAUTION

yyDisconnect the power before installing or moving the monitor. Otherwise electric shock may occur.

yyIf you install the Monitor on a ceiling or slanted wall, it may fall and result in severe injury. Use an authorized LG wall mount and contact the local dealer or qualified personnel.

yyDo not over tighten the screws as this may cause damage to the Monitor and void your warranty.

yyUse screws and wall mounts that meet the VESA standard. Any damages or injuries by misuse or using an improper accessory are not covered by the warranty.

If you intend to mount the Monitor to a wall, attach Wall mounting interface (optional parts) to the back of the set.

When you install the Monitor using the wall mounting interface (optional parts), attach it carefully so it will not fall.

1Please, Use the screw and wall mount interface in accordance with VESA Standards.

2If you use screw longer than standard, the monitor might be damaged internally.

3If you use improper screw, the product might be damaged and drop from mounted position. In this case, LG Electronics is not responsible for it.

4VESA compatible.

5Please use VESA standard as below.

NOTE

yyUse screws that are listed on the VESA standard screw specifications.

yyThe wall mount kit includes an installation manual and necessary parts.

yyThe wall mount bracket is optional. You can obtain additional accessories from your local dealer.

yyThe length of screws may differ depending on the wall mount. Be sure to use the proper length.

yyFor more information, refer to the instructions supplied with the wall mount.

yy785mm(31 inch) or greater

*Fastening screw: Diameter 6.0 mm x Pitch 1.0 mm x Length 10 mm