15
Installation and Setup
DISPLAY
TV Aspect
4:3:
Select when a standard 4:3 TV is connected.
16:9 Wide : Select when a 16:9 wide TV is
connected.
Display Mode
Display Mode setting works only when the TV Aspect
mode is set to “4:3”.
Letterbox: Displays a wide picture with bands on the
upper and lower portions of the screen.
Panscan:
Automatically displays the wide picture on the
entire screen and cuts off the portions that do not fit.
AUDIO
Each DVD disc has a variety of audio output options.
Set the player’s AUDIO options according to the type
of audio system you use.
Dolby Digital / DTS / MPEG
Bitstream: Select “Bitstream” if you connect the
DVD Player’s DIGITALOUT jack to an Amplifier or
other equipment with a Dolby Digital, DTS or
MPEG decoder.
PCM (for Dolby Digital / MPEG): Select when
connected to a two-channel digital stereo amplifier.
DVDs encoded in Dolby Digital, DTS or MPEG will
be automatically downmixed to two-channel PCM
audio.
Sample Freq. (Frequency)
If your Receiver or Amplifier is NOTcapable of
handling 96 kHz signals, select 48 kHz. When this
choice is made, this unit automatically converts any 96
kHz signals to 48 kHz so your system can decode
them.
If your Receiver or Amplifier is capable of handling 96
kHz signals, select 96 kHz. When this choice is made,
this unit passes each type of signal through without
any further processing.
Check the documentation for your Amplifier to verify
its capabilities.
DVD-ADVD-V
DivX
DVD-ADVD-V
DVD-ADVD-V
DVD-ADVD-V
Dolby Digital
Bitstream
PCM
48 kHz
Select
Bitstream
DTS
MPEG
Sample Freq.
5.1 Speaker Setup
OnDRC
OnVocal
Move
Select
AUDIO
DISPLAY
TV Aspect
Widescreen
Wide
16 : 9
Display Mode
OffProgressive Scan
Move
Select
TV Output Select RGB