LG Electronics Set the HCS6320 IP Address, Install a ProIdiom Key on All Transcoders

Configuration Options via Command Line (Cont.)

Set the HCS6320 IP Address

1.Access the HCS6320 Main Menu as described on page 30.

2.At the [Main] Command > prompt, type setip and press Enter.

3.At the Using DHCP (y/n)? prompt, either:

•Type y and press Enter if using DHCP. The system will display: IP address has been set.

Go to step 5.

•Type n and press Enter to assign a static IP address to the HCS6320. Then, continue with step 4.

4.At each of the following prompts, type the information requested. Press Enter after each entry.

Enter IP address: (Type the host IP address in the format xxx.xxx.xxx.xxx.)

Enter Subnet Mask: (Type the subnet mask in the format xxx.xxx.xxx.xxx.)

Enter Gateway: (Type the IP address of the default gateway in the format xxx.xxx.xxx.xxx.)

Once you enter the gateway address, the system will display: IP address has been set.

5.Reset the HCS6320 card (see “Perform an External Card Reset” on page 32). IP settings will not take effect until the HCS6320 resets.

Note: If you intend to modify additional configuration settings during the current session, you may wait until all changes are complete before you reset the HCS6320.

Install a Pro:Idiom Key on All Transcoders

The Pro:Idiom encrypter built into the transcoder cards contains a default encryption key. When first installed, the cards will use this key to encrypt content. This command enables you to change the encryption key, if necessary.

This command installs the Pro:Idiom key on all the transcoders installed in the chassis. To install a Pro:Idiom key on a single transcoder, see “Install a Pro:Idiom Key on the Selected Transcoder” on page 40.

Note: In order for a Pro:Idiom encrypted channel to be displayed, the receiver must contain a Pro:Idiom decrypter, and the receiver must be configured to allow decryption of the desired channel.

Note: The process of updating the encryption key will synchronize the decryption key in any receiver tuned to the cards’ output. If the target receiver is turned off or viewing content from a different card, the synchronization will not occur, and the output will be scrambled. Ensure that all encrypters and decrypters in a system are synchronized to the same key.

206-4183 33